Recording From A Microphone; Adding Track Marks Automatically (Auto Time Stamp) - Sony MZ-N707 Operating Instructions Manual

Notes
Notes
l
The setting will remain even after the power is
turned off.
l
If you start recording while the recorder is in
play-pause mode, the recording will begin
from the point at which it is paused even when
the "REC-Posi" is set to "From End".
l
The recorder automatically
switches input in
the following order; optical input, microphone
input, and analog input. You cannot record
through the microphone while an optical cable
is connected to the LINE IN (OPTICAL) jack.
l
The microphone may pick up the operating
sound of the recorder itself. Use the
microphone away from the recorder in such
cases. Do not use a microphone with a short
connector, as this may cause the operating
sound of the recorder to be picked up.
l
Only left-channel sound is recorded when a
monaural microphone is used.
Recording from a
microphone
1
i
2
3
REC
II
to MIC (PLUG IN POWER)
y- See "Optional accessories" (page 76).
Turn the power of the stereo
microphone off, and then connect it to
the MIC (PLUG iN POWER) jack.
The recorder changes to microphone
input automatically.
Turn
the power of the stereo
microphone on.
Press and slide REC to the right.
For other operations, see "Recording
an MD right away! (Synchro-
recording)" (page 18).
Adding track marks
automatically (Auto
Time Stamp)
Use this feature to add track marks
automatically at specified intervals wher
recording through the analog input
connector or a microphone.
1
2
3
ENTER/ MENU
n
While the recorder is recording or in
recording pause, press MENU.
Press I44 or bbl repeatedly until
"TIME MARK" flashes in the
display, and then press ENTER.
Press I44 or bbI repeatedly until
the desired time interval flashes in the
display, and then press ENTER.
Select one of the following intervals:
) Display 1 Time
1 OFF
-
I