Toro 315-8 User Manual page 150

GLOSSARY
The clutch should be burnished as part of the pre
delivery service, or whenever a new clutch is installed.
Burnishing polishes the clutch plate, allowing for
smooth clutch engagement.
With a PTO driven attachment installed (i.e., mower,
snowthrower, or tiller), run the engine at half throttle.
Engage and disengage the clutch 5 times (10 seconds
on/10 off).
The 20 amp fuse is located at the right side of the fuel
tank. It is wired in series between the battery positive
terminal and the "B" terminal of the ignition switch
(Figure 3).
3-7
Fuses are electrical safety valves that protect wiring
and electrical components from damage from high
Never connect a jumper wire across a fuse. Never
connect additional fuses in parallel.
the reason for a blown fuse.
fuseIII