Unfolding The Handle; Installing The Discharge Chute - Toro Snow Commander 38602 Operator's Manual

1. Unfolding the Handle

1. Cut the plastic tie that secures the control cable to the
handle.
2. Loosen the knobs and pull out the handle bolts (Figure
3).
Figure 3
3. Rotate the upper handle to the operating position
(Figure 4).
Figure 4
4. Install the handle bolts, set the cable guide in position,
and tighten the knobs until they are snug (Figure 5).
Figure 5
5. Adjust the rotor control cable and the traction drive
cable. Refer to Adjusting the Rotor Control Cable and
to Adjusting the Traction Drive Cable.
2. Installing the Discharge
Chute
Install the discharge chute as shown (Figure 6).
Figure 6
6