General Specifications - Toro 03550 Reelmaster 5500-D Operator's Manual

General Specifications

Engine
Main frame
Cooling system
Fuel system
Traction system
Ground speed
Cutting unit drive system
Seat
Steering system
Tires
Brakes
Electrical features
Controls
Gauges
Diagnostics
Kubota three cylinder, 4 cycle, liquid cooled, turbo diesel engine. 35 hp @ 3000
rpm. Governed to 3200 rpm. 68–1/2 cubic inch (1123 cc) displacement. Heavy duty,
3-stage, remote mounted air cleaner. High water temperature shutdown switch.
All welded formed steel frame, includes tie-down loops
Radiator capacity is approximately 240 ounces (9.4 l) of 50/50 mixture of ethylene
glycol anti–freeze. Remote mounted 32 ounces (.9 l) expansion tank. Removeable
oil cooler/radiator intake screen. Air to oil cooler, mounted to front of radiator, tips
forward for cleaning.
Fuel tank capacity is 10 gallons (57 l) of #2 diesel fuel. Equipped with a fuel
filter/water separator to capture water in the fuel.
Foot pedal controls forward/reverse ground speed. Hydrostatic transmission
mounted directly on a 20.9:1 ratio front axle. Axle/reservoir capacity is 160 ounces
(4.7 l). Replaceable filter mounted directly on transmission housing. Model 03551
only–Mechanical rear axle is coupled to front axle by a driveshaft and overrunning
clutch.
0–10 mph forward, 0–4 mph reverse
Reel motors feature quick disconnect for removal or installation onto cutting unit.
Hydraulic fluid reservoir capacity is 8–1/2 gallons. System protected by a filter
assembly with restriction bypass and service indicator.
Deluxe high back suspension seat with adjustable fore and aft travel, weight and
height. Tool box at left side of seat.
Power steering with dedicated power source
Two rear steering tires: 20 x 10.00-10, tubeless, 6-ply rating. Two front traction
drive tires: 26.5 x 14.00-12 tubeless, 4-ply rating. Recommended tire pressure for
front and rear tires is 10–15 psi.
Individual drum type wheel brakes on front traction wheels. Brakes controlled by
individual pedals operated by the left foot. Hydrostatic braking through traction
drive.
Automotive type electrical system. 12 volt, maintenance free battery with 530 cold
cranking Amps @ 0 degrees F. and 85 minute reserve capacity @ 85 degrees F.
40 amp alternator with I.C. regulator/rectifier. Seat switch, reel and traction interlock
switches. An electronic controller monitors and controls safety and operational
functions. Parking brake switch and individual circuit backlap switches.
Foot operated traction and brake pedals. Hand operated throttle, speed control
lever, parking brake lock, ignition switch with automatic preheat cycle, single joy
stick control for cutting unit on/off and lift lower. Cutting unit backlap controls and
reel speed controls located under seat base.
Hour meter, speedometer, fuel gauge, temperature gauge, 4 bank warning lamp: oil
pressure, water temperature, amps, and glow plug.
The Automatic Control Electronics, ACE™ system allows precise timing and control
of machine functions for maximum reliability. Optional diagnostic display connects
to an electronic control unit to pin point any electrical problems quickly and easily.
Available DATA LOG™ system allows mechanic to find intermittent problems.
12