Hour Meter
The hour meter (Figure 4) shows the total hours
that the machine has been operated.
Temperature Override Switch
Press and hold the reset switch (Figure 4) to start
the engine after high temperature shut down. Use
only for emergency operation.
Audible Alarm
The alarm (Figure 4) is activated when the low
engine oil pressure light illuminates or the high
coolant temperature light illuminates.
Specications
Note: Specifications and design are subject to change without notice.
Width of cut
overall
front cutting unit
side cutting unit
front and one side cutting
unit
Overall width
cutting units down
cutting units up (transports)
Overall length
Height
Height with ROPS
Ground clearance
Wheel tread (to center of tire)
front
rear
Wheel base
Weight (with cutting units and
uids)
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or Distributor or
Alarm Silence Switch
This switch (Figure 4) shuts off the audible alarm.
Throttle Control
Move the control (Figure 4) forward to increase the
engine speed and rearward to decrease the speed.
Power Point
The power point (Figure 4) is used to power
optional electrical accessories.
go to www.Toro.com for a list of all approved
attachments and accessories.
124 inch (315 cm)
54 inch (137 cm)
37 inch (94 cm)
89 inch (226 cm)
127 inch (322 cm)
71 inch (180 cm)
144 inch (366 cm)
58 inch (147 cm)
81 inch (206 cm)
6 inch (15 cm)
45 inch (114 cm)
47 inch (119 cm)
55-1/2 in (141 cm)
3905 lb (1757 kg)
18