Toro 02000 GROUNDS PRO 2000 Operator's Manual page 18

Operation
maintenance machines. Issues to consider when
operating are the traction drive, engine speed and the
load on the cutting units. Regulate the traction pedal to
keep engine rpm high and somewhat constant while
mowing to maintain adequate power for the traction and
cutting units.
Follow operating guidelines presented in this manual and
know how to operate the machine safely on all types of
terrain. Use the slope gauge, page 34, to determine slope
angles of questionable areas. Hills (or slopes) over 15
degrees should be traversed or mowed up and down, not
side to side and hills over 20 degrees should generally be
avoided unless special safeguards, skills and conditions
exist.
Always plan well ahead to avoid the need for sudden
stops, starts or turns. To stop, use the reverse pedal for
braking. Before stopping the engine, disengage all
controls, move the throttle to IDLE, and set the parking
brake.
This product may exceed noise levels of 85
CAUTION:
dB(A) at the operator position. Ear protectors are
recommended for prolonged exposure to reduce the
potential of permanent hearing damage.
TRANSPORT OPERATION
Be sure the lift arms are fully raised and the transport
bracket is installed and secured with the retainer (Fig.
13). Also, lock the rear cutting unit in the raised position
(Fig. 14).
While operating on slopes and uneven terrain, always
reduce speed and use extreme caution before turning to
reduce risk of tipping or losing control. Watch carefully
and avoid holes in the terrain, sudden drop-offs and other
hazards. To prevent costly damage and down time,
familiarize yourself with the width of the Grounds Pro
2000. Do not attempt to pass between immovable objects
placed close together.
18
1. Transport bracket
1
1. Rear cutting unit lock-up lover
INSPECTION AND CLEAN-UP
AFTER MOWING
After mowing, thoroughly wash the machine with a
garden hose—without a nozzle—so excessive water
pressure will not cause contamination and damage seals
and bearings.
Note: Do not spray water directly onto a hot engine or
hot bearings.
Make sure the cooling fins and the area around the
engine air intake are kept free of dirt or grass clippings.
After cleaning, inspect the machine for possible
hydraulic fluid leaks, damage or wear to hydraulic and
mechanical components. Check the cutting units for
Figure 13
Figure 14