Toro 68048 Operator's Manual page 7

Throttle Handle
Pull the throttle handle (Figure 3) to increase the engine speed,
and push the handle to decrease the engine speed. Turn the
handle clockwise to lock the throttle at a specific speed. Turn
the handle counterclockwise to unlock the throttle.
Handle-adjustment Knob
Turn the knob counterclockwise to loosen and move the
handle to the desired position. Turn the knob clockwise to
tighten and lock the handle in place (Figure 3).
Dyna-Clutch Lever
Move the Dyna-Clutch lever (Figure 5) to the On position
(up) to allow the blades to rotate. Move the lever to the Off
position (down) to stop the blades. In the event that the
operator releases the handle while the blades are turning, the
centrifugal force from the swing of the handle will throw the
clutch lever to the Stop position.
g019978
1. Dyna-Clutch lever
ProPitch TM Handle
Models 68049 and 68051 only
Pull the handle to increase the angle of the blades to the
concrete. Press the trip button to release the lock, and push
the handle to decrease the angle of the blades.
Figure 5
1. Trip button
Tilt-adjustment Knob
Models 68048 and 68050 only
Turn the knob clockwise to increase the angle of the blades
(Figure 6). Turn the knob counterclockwise to flatten or
decrease the angle of the blades.
1
1. Tilt-adjustment knob
7
2
1
Figure 6
2. Handle
1
g021559
Figure 7
G019367