Figure 14
6
Installing the Motion Control
Levers
Parts needed for this procedure:
1
Right control lever
1
Left control lever
4
Bolt (3/8 x 1 inch) (2 are assembled)
4
Curved washer (3/8 inch) (2 are assembled)
Procedure
1. Rotate the motion control levers to the upright
position.
2. Loosely install the control levers on the outside of
the posts, using 4 bolts and 4 curved washers.
Note: Install the control levers in the top and
middle holes for the high position or the middle and
bottom holes for the low position, as desired.
Figure 15
3. Raise the levers and align them together in the
neutral position and tighten the bolts.
Note: If the machine is not properly tracking, refer
to Adjusting the Tracking in your Operator's Manual.
7
Adding Fuel to the Machine
No Parts Required
Procedure
Add fuel to the machine before starting it. Refer to your
Operator's Manual. for the correct fuel and procedure.
6
Figure 16