Sound Pressure Level; Sound Power Level; Vibration Level - Toro 30581 Groundsmaster 580-D Operator's Manual

Traction and cutting units

Hide thumbs Also See for 30581 Groundsmaster 580-D:

Operator's manual (48 pages)

Table Of Contents

Table of Contents

Check the safety interlock switches daily for proper

operation. If a switch should fail, replace the switch

before operating the machine. After every two years,

replace all interlock switches in the safety system,

whether they are working properly or not.

Before starting the engine, sit on the seat.

Using the machine demands attention. To prevent loss

of control:

– Do not drive close to sand traps, ditches, creeks,

embankments, or other hazards.

– Reduce speed when making sharp turns. Avoid

sudden stops and starts.

– When near or crossing roads, always yield the

right-of-way.

– Apply the service brakes when going downhill to

keep forward speed slow and to maintain control of

the machine.

When operating a machine on slopes, by banks, or drop

offs, always have ROPS (roll–over protection system)

installed.

When operating a machine with ROPS (roll–over

protection system) always use the seat belt and make

sure seat pivot retainer pin is installed (GM only).

Raise the cutting units when driving from one work

area to another.

Do not touch the engine, silencer/muffler, or exhaust

pipe while the engine is running or soon after it has

stopped because these areas could be hot enough to

cause burns.

On any hill, there is the possibility of tipping or rolling

over, but the risk increases as the slop angle increases.

Steep hills should be avoided.

– Cutting units must be lowered when going down

slopes to maintain steering control

Engage traction drive slowly, always keep foot on

traction pedal, especially when traveling downhill.

– Use reverse on traction pedal for braking.

If the machine stalls when climbing a slope, do not turn

the machine around. Always back slowly, straight down

the slope.

When a person or pet appears unexpectedly in or near

the mowing area, stop mowing. Careless operation,

combined with terrain angles, ricochets, or improperly

positioned guards can lead to thrown object injuries. Do

not resume mowing until the area is cleared.

Maintenance and Storage

Make sure all hydraulic line connectors are tight and all

hydraulic hoses and lines are in good condition before

applying pressure to the system.

Keep your body and hands away from pin hole leaks or

nozzles that eject hydraulic fluid under high pressure.

Use paper or cardboard, not your hands, to search for

leaks. Hydraulic fluid escaping under pressure can have

sufficient force to penetrate the skin and cause serious

injury. Seek immediate medical attention if fluid is

injected into skin.

Before disconnecting or performing any work on the

hydraulic system, all pressure in the system must be

relieved by stopping the engine and lowering the cutting

units and attachments to the ground.

Check all fuel lines for tightness and wear on a regular

basis. Tighten or repair them as needed.

If the engine must be running to perform a maintenance

adjustment, keep hands, feet, clothing, and any parts of

the body away from the cutting units, attachments, and

any moving parts.

To ensure safety and accuracy, have an Authorized Toro

Distributor check the maximum engine speed with a

tachometer.

If major repairs are ever needed or if assistance is

desired, contact an Authorized Toro Distributor.

Use only Toro-approved attachments and replacement

parts. The warranty may be voided if used with

unapproved attachments.