Replacing The Fuel Filter; Servicing The Transaxle Fluid; Servicing The Fuse - Toro 71228 Operator's Manual

Note: Now is the best time to install a new fuel filter
because the fuel tank is empty.
9. Install the fuel line onto the filter. Slide the hose clamp
close to the filter to secure the fuel line and filter.

Replacing the Fuel Filter

Replace the fuel filter after every 100 operating hours or
yearly, whichever occurs first.
The best time to replace the fuel filter (Fig. 28) is when the
fuel tank is empty. Never install a dirty filter if it is
removed from the fuel line.
1. Disengage the blades (PTO).
2. Set the parking brake.
3. Stop the engine and wait for all moving parts to stop.
4. Remove the ignition key.
5. Open the hood.
6. Squeeze the ends of the hose clamps together and slide
them away from the filter (Fig. 28).
7. Remove the filter from the fuel lines.
8. Install a new filter and move the hose clamps close to
the filter.
9. Close the hood.

Servicing the Transaxle Fluid

Check the fluid level after every 100 hours or yearly,
whichever occurs first. Always keep the fluid level at the
full level when the transaxle is cold.
Note: The transaxle is factory sealed and does not require
oil changes.
Fluid Type: SAE 20W-50 engine oil (API service SH/CD
recommended)
Checking the Fluid Level
1. Park the tractor on a level surface.
2. Disengage the blades (PTO).
3. Set the parking brake.
4. Stop the engine and wait for all moving parts to stop.
5. Remove the ignition key.
6. Clean around the fill plug (Fig. 29) so that dirt cannot
fall into the reservoir if fluid needs to be added.
1
m-4983
1. Fill plug
7. Remove the fill plug and check the fluid level.
Note: The level should be a maximum of 1-1/4 in. (32 mm)
below the top of the fill port (Fig. 29). Add oil if necessary.
8. Install the fill plug.

Servicing the Fuse

The electrical system is protected by fuses. No maintenance
is required; however, if a fuse blows, check the circuit
wiring for a short. To replace a fuse, pull up (Fig. 30) to
remove it from the socket. Push down to insert it.
Fuses: 10 amp, blade-type
1. Fuse (removed)
29
1-1/4 in. max.
(32 mm)
Figure 29
1
Figure 30
2. Socket
2
m-1672