Checking The Transaxle/Hydraulic Fluid; Filling The Fresh Water Tank - Toro 41165 Operator's Manual

Checking the
Transaxle/Hydraulic Fluid
1. Position the sprayer on a level surface, set the parking
brake, stop the pump, stop the engine, and remove the
ignition key.
2. Remove the transaxle dipstick and wipe it with a clean
rag (Fig. 10).
1
Figure 10
1. Dipstick
Important
Be very careful not to get dirt or other
contaminants into the opening when checking the
transmission oil.
3. Insert the dipstick into the tube and make sure it is
seated fully. Remove the dipstick and check the oil
level.
4. The transaxle fluid level should be at the top of the flat
portion of the dipstick. If it is not, fill the reservoir with
the appropriate fluid; refer to Changing the
Transaxle/Hydraulic Fluid, page 36.
5. Install the dipstick firmly in place.
2
2. Fill hole
16

Filling the Fresh Water Tank

The sprayer is equipped with a fresh water tank (Fig. 11)
for you to wash chemicals off of your skin, eyes, or other
surfaces in the case of accidental exposure. Always fill the
fresh water tank with clean water before handling or
mixing any chemicals.
1
2
Figure 11
1. Filler cap
2. Fresh water tank
To open the fresh water tank spigot, turn the lever on the
spigot.
3
3. Spigot