Adjusting The Flow Baffle; Positioning The Flow Baffle - Toro 74444 Operator's Manual

Figure 21
1. Anti-scalp roller
2. Bushing

Adjusting the Flow Baffle

The mower discharge flow can be adjusted for different
types of mowing conditions. Position the nut and baffle
to give the best quality of cut.
1. Disengage the PTO, move the motion control
levers to the neutral locked position and set the
parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. To adjust the baffle, loosen the nut (Figure 22).
4. Adjust the baffle and nut in the slot to the desired
discharge flow and tighten the nut.
1 2
Figure 22
1. Slot
3. Flange Nut
4. Bolt
g0121 19
2. Nut

Positioning the Flow Baffle

The following figures are only recommendations for
use. Adjustments will vary by grass type, moisture
content, and height of grass.
Note: If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position A
This is the full rear position. The suggested use for this
position is a follows.
• Use for short, light grass mowing conditions.
• Use in dry conditions.
• For smaller grass clippings.
• Propels grass clippings farther away from the
mower.
Position B
Use this position when bagging.
21
G012120
Figure 23
G012121
Figure 24