Toro 22304 Operator's Manual page 17

Attachment tilt lever
To tilt attachment forward, slowly push the
attachment tilt lever forward.
To tilt attachment rearward, slowly pull the
attachment tilt lever rearward.
Loader arm lever
To lower loader arms, slowly push loader arm lever
forward.
To raise loader arms, slowly pull loader arm lever
rearward.
Auxiliary hydraulics lever
POTENTIAL HAZARD
Attachment may move during starting
WHAT CAN HAPPEN
Operator or bystander may be injured by
attachment
HOW TO AVOID THE HAZARD
Make sure auxiliary hydraulic lever is in
neutral position during engine starting.
To operate attachment in forward direction, slowly
pull auxiliary hydraulics lever rearward.
To operate attachment in reverse direction, slowly
push auxiliary hydraulics lever forward.
Pump selector lever
When faster ground speed and lifting speed is
required more than attachment speed and power,
push pump selector lever to the full forward position.
When faster attachment speed and power is required
more than ground speed and lifting speed, pull pump
selector lever to the full rearward position.
Flow divider control
Move flow divider control to twelve–o'clock position
(normal operating position) for no flow division.
When moving control to nine–o'clock position, flow
is diverted to the attachments and less is available to
the wheels and loader arms. This allows for greater
concentration of power where it's needed most.
1
Figure 9
1. Flow divider control
Operation
15