Fuse; Headlights - Toro 71233 Operator's Manual

Fuse

Service Interval/Specification
The electrical system is protected by fuses. No maintenance
is required, however, if a fuse blows, check the circuit
wiring for a short. To replace a fuse pull up (Fig. 31) to
remove it from the socket. Push down to insert it.
Fuse: 10 amp, blade-type
Figure 31
1. Fuse (removed)

Headlights

Specification: Bulb # 1156, automotive type
Removing the Bulb
1. Disengage the PTO, set the parking brake, stop the
engine, and remove the ignition key.
2. Open the hood. Pull the wire connectors off of both
bulb holder terminals.
3. Rotate the bulb holder 1/4 turn counterclockwise and
remove it from the reflector (Fig. 32).
4. Push and rotate the bulb counterclockwise until it stops
(approx. 1/4 turn) and remove the bulb from the bulb
holder (Fig. 33).
1
2
1672
2. Socket
26
5
3
2
4
Figure 32
1. Bulb holder
2. Reflector
3. Tabs
Installing the Bulb
1. The bulb has metal pins on the side of its base. Align
the pins with the slots in the bulb holder and insert the
base into the holder (Fig. 33). Push and rotate the bulb
clockwise until it stops.
2
4
3
Figure 33
1. Bulb
2. Metal pins
2. The bulb holder has two tabs (Fig. 32). Align the tabs
with the slots in the reflector, insert the bulb holder into
the reflector, and rotate it 1/4 turn clockwise until it
stops.
3. Push the wire connectors onto the terminals on the bulb
holder.
5
1
4
1874
4. Slots
5. Terminals
1
2
4
1875
3. Bulb holder
4. Slots