Touch Screen - Kenwood DDX5032 Service Manual

Frequency : Default value of the set
Note that the frequency remains unchanged after exiting
from the Setup screen at the completion of the setup.
3.7 Direct Select screen
Transfer to the Direct Select screen. Source Direct screen
shall have the screen that has 9 keys. Audio Control/Setup
shall be done in the same manner as in the normal screen
transfer.

3.8 Touch screen

Fine-tune the variations of touch feeling in of each set.
Touch 4 markers one by one, and the adjustment is com-
pleted when the "Write OK" is shown on the screen.
If the "Write NG" is shown, transfer to the Test mode again
to re-start the adjustment from the fi rst step.
The Touch Adjustment screen is shown in Figure 3.8.
Touch Adjust
1-point being input 2-point being input
Cancel
3-point being input 4-point being input
Figure 3.8 TOUCH screen
Key Specifi cation
Cancel : When the Cancel button is pressed while enter-
ing the 1st point, the system transfers to the Test
Mode Main screen.
When the Cancel button is pressed while enter-
ing the other point than the 2nd point, the system
transfers to the status to enter the 1st point.
Return : Transfer to Test Mode Main screen
TEST MODE
Touch Adjust
Wite OK/NG
Return
DDX5022/5022Y/5032/5032M/512/52RY
DNX5120/512EX/5220/5220BT
3.9 HPOSI screen
Adjust horizontal position of each screen.
The screen shall be transferred like; "Graphic→NAVI".
Graphic and NAVI of DNX are used in the adjustment of Dot
FREQ/Phase. The Adjustment screen is shown in Figure 3.9.
HPOSI Adjust
Next
Graphic
(NAVI)
HPOSI
Step value
<<
>>
Dot FREQ
Step value
>>
<<
Dot Phase
Step value
<< >>
Cancel
Figure 3.9 HPOSI screen
Key Specifi cation
Next : Transfer to the next HPOSI Adjustment screen.
When the screen is NAVI, the screen starts writing
in the E2PROM.
<< : Screen toward the left.
>> : Screen toward the right.
Cancel : Transfer to Test Mode Main screen
Return : Transfer to Test Mode Main screen
If HPOSI NG (E2PROM Write NG) is shown, transfer to the
Test Mode again to start over the adjustment.
3.10 iPod screen
Check communication for iPod authentication.
The iPod screen is shown in Figure 3.10.
iPod Check
iPod Check
Cancel
Figure 3.10 iPod screen
Key Specifi cation
iPod Check : Start checking communication for iPod
authentication.
Cancel, Return : Transfer to Test Mode Main screen
HPOSI Adjust
HPOSI OK/NG
Return
iPod Check
iPod OK/NG
Return
19