Positioning The Deluxe Seat - Toro 31223 Operator's Manual

Positioning the Deluxe Seat

1. Fore/Aft adjustment lever
2. Weight adjustment lever
3. Backrest locking lever
Changing the Weight Adjustment
The seat can be adjusted to provide a smooth and comfortable
ride.
Important: To adjust the seat for the drivers weight the
driver must be seated and the ignition key moved to the
On position.
The seat is adjusted for the driver's weight by pulling or
pressing the weight adjustment lever
The driver's weight is adjusted correctly when the arrow is in
the middle clear area of the viewing window.
Within this viewing area, the seat can be adjusted to a
minimum spring movement.
When the minimum/maximum weight adjustment has been
reached, you can hear it reaching the upper or lower end stop.
Important: To prevent injury to the operator and/or
damage to the machine, the setting for the driver's
weight and the seat must be checked and adjusted
before the machine is operated.
Note: To avoid compressor damage during weight
adjustment, the compressor must be operated no longer than
1 minute.
Changing the Seat Position
The seat can move forward and backward. Position the seat
where you have the best control of the machine and are most
comfortable.
1. To adjust, lift the lever to unlock the seat
2. Slide the seat to the desired position and release lever
to lock in position.
Figure 22
4. Armrest adjustment knob
5. Lumbar support adjusting
knob
(Figure 22).
(Figure
3. Verify that the seat has locked into place by attempting
to move it back and forth.
Note: Do not operate the locking lever while
operating the machine.
Changing the Lumbar Support
The lumbar support increases both the seating comfort and
the performance of the driver.
The back of the seat can be adjusted to provide a customized
lumbar support for your lower back.
By turning the adjustment knob upwards, the curvature in
the upper part of the backrest cushion can be adjusted. By
turning the knob downwards, the curvature in the lower part
of the backrest cushion can be adjusted
0 = No curvature
1 = Maximum curvature at the top
2 = Maximum curvature at the bottom
Adjusting the Armrests
The armrests can be folded back if required and the height
individually adjusted.
To adjust the armrests for height, separate the round cap
(Figure 22) from the cover, loosen the hexagon nut (13 mm)
behind it and adjust the armrests to the desired position and
tighten the nut. Replace the cap onto the nut.
WARNING
Do not install the armrest in the lowest position as
the seat belt roller might not function properly.
Changing the Armrest Angle
The angle of the armrests can be adjusted for operator
comfort.
To adjust the angle of the armrests, turn the adjustment knob
(Figure 22).
When turning the knob to the outside (+) the front part of
the armrest will be lifted, when turning the knob to inside (-)
it will be lowered.
Changing the Backrest Position
The back of the seat can be adjusted to provide a more
comfortable ride. Position the back of the seat where it is
most comfortable.
Pull up the locking lever to release the backrest catch
22).
22). When releasing the backrest catch, do not apply load to
the backrest by pressing against it.
25
(Figure 22).
(Figure