Adjusting The Motion-Control Damper; Adjusting The Motion-Control Neutral Lock Pivot - Toro 74906 Operator's Manual

the jumper wire being used. Run the engine at full
throttle and release the brake.
6. Run the machine at least 5 minutes with the drive
levers at full forward speed to bring hydraulic oil up
to operating temperature.
Note: The motion-control lever needs to be in neutral
while making any necessary adjustments.
7. Bring the motion-control levers into the neutral
position.
8. Adjust the pump control rod lengths by rotating the
double nuts on the rod in the appropriate direction
until the wheels slightly creep in reverse
g027342
Figure 86
1. Double nuts
9. Move the motion-control levers to the reverse position
and while applying slight pressure to the lever allow
the reverse indicator springs to bring the levers back
to neutral.
Note: The wheels must stop turning or slightly creep
in reverse.
10. Stop the engine, remove the jumper wire from the wire
harness, and plug the connector into the seat switch.
11. Remove the jack stands.
12. Raise the deck and install the height-of-cut pin.
13. Check that the machine does not creep in neutral with
the parking brake disengaged.
Adjusting the Motion-Control
Damper
The top damper mounting bolt can be adjusted to obtain a
more desired motion-control lever resistance. See
for mounting options.
(Figure 86).
1. Torque the locknut to 23 N-m (17 ft-lb). The bolt must
protrude past the end of the locknut after torquing.
2. Most resistance (firmest feel)
3. Damper
4. Medium resistance (medium feel)
5. Least resistance (softest feel)
Adjusting the Motion-Control
Neutral Lock Pivot
The flanged nut can be adjusted to obtain a more desired
motion-control lever resistance when moving it to the neutral
lock position. See
1. Loosen the jam nut.
2. Tighten or loosen the flanged nut to the desired feel.
3. Tighten the jam nut.
54
Figure 87
Right-hand motion control shown
Figure 88 for adjustment options.
For more resistance, tighten the flanged nut.
For less resistance, loosen the flanged nut
Figure 87