Positioning The Seat; Unlatching The Seat - Toro 74448 Operator's Manual

2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. After adjusting the height-of-cut, adjust the rollers
by removing the flange nut, bushing, spacer, and
bolt (Figure 19 , Figure 20 and Figure 45 ).
Note: The two middle rollers will not have a spacer
(Figure 20).
4. Select a hole so the anti-scalp roller is positioned to
the nearest corresponding height-of-cut desired.
5. Install the flange nut bushing, spacer, and bolt.
Torque to 40-45 ft-lb (54-61 N•m) (Figure 19 ,
Figure 20 and Figure 45 ).
6. Repeat this adjustment on the other anti-scalp
rollers.
Figure 19
1. Anti-scalp roller
2. Spacer
3. Bushing
4. Flange Nut
5. Bolt
1. Anti-scalp roller
2. Bushing

Positioning the Seat

The seat can move forward and backward. Position the
seat where you have the best control of the machine
and are most comfortable.
Important: To adjust, move the lever sideways to
unlock seat (Figure 21).
Slide the seat to the desired position and release lever
to lock in position.
1. Adjustment lever

Unlatching the Seat

Push the seat latch rearward to unlatch the seat.
This will allow access to the machine under the seat
(Figure 22).
20
Figure 20
3. Flange Nut
4. Bolt
Figure 21