Toshiba D-R150SB Owner's Manual page 15

3
• The following setting is required according to the TV that
you are connecting. Perform this setting after step 4.
TV
Normal TV
TV compatible with
S video signals
RGB monitor
4
To wall outlet
Notes
• Refer to the owner's manual of the connected TV as well.
• When you connect the recorder to your TV, be sure to turn off the power and unplug both units from the wall outlet before any
connections.
• Connect the recorder directly to your TV. If you connect the recorder via a VTR, TV/VTR combination or video selector, the
playback picture may be distorted due to copy protection.
03_D-R150SB(E)_inst_13-20
Downloaded From Disc-Player.com Toshiba Manuals
Connect to a TV equipped with SCART inputs.
Connect as below for watching received channels or recorded contents. Watching via the RF OUT terminal
is not available.
To AV1(TV)
Setting "AV1 output" on the
"Audio out select" on the
"Initial settings" menu. "Picture/Audio settings"
page 38 menu.
"Video"
"S-Video"
"RGB"
Connect the power cord of the recorder to a wall outlet.
15
SCART cable (not supplied)
page 40
"Analog 2ch"
"Analog 2ch"
To SCART input
"Analog 2ch"
Plug & Auto Set Up function
This recorder will automatically set itself up when it is plugged
into the mains for the first time.
TV stations will be stored in the recorder's memory. The process
will finish after a few minutes. Then the date and time are set
automatically from broadcast signal.
Notes
• The display on the recorder shows "Auto" while the Plug & Auto Set
Up function is running.
• TV stations are stored in the range of UHF E21-E69.
• You can only use the ON/STANDBY button and OPEN/CLOSE button
while the Plug & Auto Set Up function is running.
• The automatic setup is cancelled, if you press the ON/STANDBY
button while the Plug & Auto Set Up function is running.
• The Plug & Auto Set Up function may not work, depending on the
radio reception or other conditions. In this case, refer to "Initial
settings" in this Owner's Manual for the setup.
To use the phono type jacks to connect the TV (
the component video jacks to connect the TV (
connect the satellite receiver (
necessary connection before connecting the power cord.
For connections to TVs with no SCART
inputs, see "Connecting to a TV equipped
with phono type jacks" ( page 16).
• Normal TV
• TV compatible with S video signals
• RGB monitor
page 16), to use
page 17), or to
pages 18, 19) complete the
05.7.13, 0:23 AM
15