Placing Machine In Neutral; Stopping The Machine; Transporting Machines - Toro Proline 30187 Operator's Manual

Driving Forward
1. To go forward, slowly press on the upper control bar
against the reference bar (Figure 14).
2. To go straight, apply equal pressure to both ends of the
upper control bar (Figure 14).
3. To turn, release pressure on the upper control bar side
toward the direction you want to turn (Figure 14).
4. Adjust reference bar to maintain a comfortable pre-set
ground speed (Figure 14).
5. To stop, release the upper control bar to stop both
wheels (Figure 14).
Note: If the front of the deck lifts off the ground when the
upper control bar is quickly pushed forward or the machine
is unable to drive uphill, an adjustment may be needed.
Refer to Adjusting the By-pass Valve on page 27.
1
2
Figure 14
1. Upper control bar
2. Reference control bar
Driving Backward
1. To go backward, slowly pull the control bar rearward
(Figure 14).
2. To go straight, apply equal pressure to both ends of the
upper control bar (Figure 14).
3. To turn, release pressure on the upper control bar side
away from the direction you want to turn (Figure 14).
4. To stop, release the upper control bar to stop both
wheels (Figure 14).
3
m–7542
3. Quick release lever
18

Placing Machine in Neutral

Release the upper control bar to stop. The machine will
automatically return to neutral. When in neutral, the
hydrostatic drive system will provide dynamic braking so
the machine will not roll.
Note: Very slow drive motion with engine running and the
control in neutral is normal. Excessive drive motion when
the control is in neutral may indicate adjustment is needed.
Refer to Adjusting the Machine Neutral on page 29.

Stopping the Machine

1. To stop, release the upper control bar to stop both
wheels (Figure 14).
2. Release the blade control bail (PTO), to stop the mower
blades. Move the engine speed throttle control to to the
slow position.
3. Turn the ignition key to off. Remember to remove the
key from the ignition switch.
Important
If the machine is on a slope, block the
wheels to prevent the machine from slowly rolling.
Important
If the machine will be left unattended, close
the fuel shut off valve and disconnect the wire(s) from the
spark plug(s).
Caution
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and chock or block
tires when leaving the machine unattended, even if
just for a few minutes.

Transporting Machines

Use a heavy-duty trailer or truck to transport the machine.
Ensure that the trailer or truck has all necessary lighting
and marking as required by law. Please carefully read all
the safety instructions. Knowing this information could
help you, your family, pets or bystanders avoid injury.
To transport the machine:
• Chock or block wheels.
• Securely fasten the machine to the trailer or truck with
straps, chains, cable, or ropes.