Table of Contents
Advertisement
INSTALLATION PARTS
1. Bracket (L)
2. Bracket (R)
3. Bracket (B)
4. Hexagonal bolt (M6 x 20)
5. Hexagonal bolt with washer (M5 x 8)
INSTALLATION
Procedure for Installation on Carpet (Horizontal Position)
1. Attach bracket (L) and bracket (R) using the hexagonal bolts (M5 x 8).
2. Attach brackets (L) and (R) to their respective brackets (B) using the hexagonal bolts (M6 x 20) and the hexagonal nuts (M6).
3. Lift the carpet and determine the mounting location. Remove the protective paper from one side of the double sided tape and apply
a piece on the bottom of both (B) brackets. Then remove the protective paper from the exposed side of the double sided tape.
4. Press the unit to the floor, then remove the screws and lift off the changer.
5. Lay down the carpet. Cut a "X" on each area of the carpet where a mounting bolt will pass through.
6. Mount the unit in place, using four hexagonal nuts (M6).
Procedure for Installation on Carpet (Vertical Position)
1. It is necessary to change the spring attachment position.
1) Remove the lock screws on the side of the set using a Phillips screwdriver.
2) Turn the spring attachment to the (V) mark side using a screwdriver.
3) Reset the screws on the (V) mark side.
4) Attach bracket (L) and bracket (R) using the hexagonal bolts (M5 x 8).
2. Attach brackets (L) and (R) to their respective brackets (B) using the hexagonal bolts (M6 x 20) and the hexagonal nuts (M6).
3. Lift the carpet and determine the mounting location. Remove the protective paper from one side of the double sided tape and apply
a piece on the bottom of both (B) brackets. Then remove the protective paper from the exposed side of the double sided tape.
4. Press the unit to the floor, then remove the screws and lift off the changer.
5. Lay down the carpet. Cut a "X" on each area of the carpet where a mounting bolt will pass through.
6. Mount the unit in place, using four hexagonal nuts (M6).
Procedure for Rear Tray Installation
1. Attach bracket (L) and bracket (R) to each side of the unit, using the hexagonal bolts with washer (M5
2. Determine the mounting location and drill four mounting holes.
3. Mount the unit in place, using hexagonal bolts (M6 x 20) and hexagonal nuts (M6).
6. Tapping Screw (M5 x 12)
7. Nut (M6)
6. Seal
9. Double sided tape
10. DIN 8pin cable
Drill holes approximately 6.5 mm in
diameter.
11.
Power Cable (Yellow)
8).
x
Advertisement
Table of Contents
