Positioning The Seat; Headlights; Using The Blade Control (Pto); Setting The Height-Of-Cut - Toro 71199 Operator's Manual

Positioning the Seat

The seat can move forward and backward. Position the seat
where you have the best control of the machine and are
most comfortable.
1. Raise the seat and loosen the adjustment knob (Fig. 3).
2. Move the seat to the desired position and tighten the
knob.
Figure 3
1. Adjustment knob

Headlights

Headlights are optional on some models. A dash-mounted
On/Off switch (Fig. 1) controls the headlights. The lights
only shine while the engine is running and the switch is On.

Using the Blade Control (PTO)

The blade control (PTO) engages and disengages power to
the blade(s).
Engaging the Blade(s)
1. Depress the clutch/brake pedal to stop the machine.
2. Move the blade control (PTO) to Engaged (Fig. 4).
1
1. Disengaged
2. Engaged
Disengaging the Blade(s)
m–1862
1. Depress the clutch/brake pedal to stop the machine.
2. Move the PTO to Disengaged (Fig. 4).

Setting the Height-of-Cut

The height-of-cut lever (deck lift) is used to raise and lower
the mower to the desired cutting height. The cutting height
may be set in one of seven positions from approximately 1
to 4 in. (25 to 102 mm).
Pull on the height-of-cut lever (deck lift) and move it to the
desired position (Fig. 5).
1
m–1881
1. Height-of-cut lever
(deck lift)
13
2
1
Figure 4
3. Blade control (PTO)
Figure 5
3
m–1852
1 in. (25 mm)
1-1/2 in. (38 mm)
2 in. (51 mm)
2-1/2 in. (64 mm)
3 in. (76 mm)
3-1/2 in. (89 mm)
4 in. (102 mm)