Prior To Operation - Hitachi CG 18DSDL Handling Instructions Manual

English
NOTE
Do not give a strong shock to the switch panel or break it. It may lead to a
trouble.

PRIOR TO OPERATION

CAUTION
Pull out battery before doing
any assembly.
1. Installing the loop handle (Fig. 6)
(1) Remove the M6 × 43 bolts (2 pcs.).
(2) Install the loop handle on the main
pipe so that it leans against the
housing.
(3) Place the handle fi xture at the lower
end of the main pipe and secure it fi rmly using M6 × 43 bolts (2 pcs.) and
M6 nuts (2 pcs.).
NOTE
Secure the loop handle in a location that provides a good grip.
CAUTION
Install the loop handle properly and securely as instructed in the
handling instructions.
If not attached properly or securely, it may come off and cause
injury.
2. Installing cover (See Fig. 7 and 8)
WARNING
Be sure to install the cover in its
designated location.
Failure to heed this warning may
result in injury from fl ying stones.
NOTE
Use the supplied hex. bar wrench 4
mm for installation.
(1) Use the supplied D5 tapping screw to
install the knife in the cover. (Fig. 7)
M6 nuts
Loop handle
D5 tapping
screw
Cover
M6×25 hex. socket button bolts
Cover
42
Housing
side
Main pipe
Handle fi xture
M6×43 bolts
Fig. 6
Knife
Fig. 7
Spring washer M6
Cover bracket
Cover holder
Fig. 8