D-Link DVG-G1402S Configuration

Hide thumbs Also See for DVG-G1402S:

Download this manual See also: Owner's Manual, User Manual

DVG-G1402S Configuration for GOtalk

In the following guide we will cover all of the settings required to configure your DVG-G1402S with your

GOtalk VoIP Account.

Factory Reset

It is recommended to factory reset your router before we proceed with the correct settings to ensure that

all the settings that we enter are stored correctly. To factory reset the unit power on the unit and wait for

it to be in a system idle state (about 30-40 seconds after power on) then press and hold the Factory Reset

button. Continue to hold the Factory Reset button for 10-15 seconds then release; this will then restart

the unit In a Factory Default state.

Reset Button is shown above by the red arrow

Accessing the Web Interface

Now to configure your unit from scratch we will need to connect to the interface via a Web Browser. Any

browser will be fine but for this guide we will be using Internet Explorer 6.0 (IE6). To log into the router

open up IE6 and type "http://192.168.15.1" into the address bar. This will now prompt you for a

username and password to configure the DVG-G1402S as shown below:

Username: "admin", Password: "admin"

You will now need to enter the username and password to access the device. The username will be

"admin" and the password is also "admin". Once you have entered the username and password press the

OK button.

Page 1 DVG-G1402S Configuration for GOtalk In the following guide we will cover all of the settings required to configure your DVG-G1402S with your GOtalk VoIP Account. Factory Reset It is recommended to factory reset your router before we proceed with the correct settings to ensure that all the settings that we enter are stored correctly.
Page 2 Configuring the Connection to the Internet Now that we have accessed the DVG-G1402S’s Web Interface we will now need to configure the router for Internet connection. Select Home tab on top and then click on WAN button on the left.
Page 3 Configuring the SIP Server for GOtalk We now need to configure the SIP Settings for your GOtalk VoIP Account. This is done by clicking on the Home tab at the top of the page and then selecting the VoIP button in the left hand navigation bar. You should see the below page appear: From the above selection press on Server Configuration.
Page 5 In order to save these changes permanently we will need to do a Reboot of that router but for now just click on the OK button and we will Save the settings and Reboot the router when all settings are completed.
Page 6 Retype Password: <GOtalk Password> ** Please note that you can find your GOtalk Username and Password on a white sticker on the underside of the DVG-G1402S ** Once you have entered all of the above settings into the unit click on the Apply button to Save the settings.