Lubrication
Greasing the Machine
Service Interval: Every 25 hours
Lubricate the 13 grease fittings on the mower using
a No. 2 multipurpose lithium base grease. A hand
operated grease gun is recommended for best results.
The grease fitting locations are as follows:
• 2 on the front roller (Figure 11)
• 2 on the reel bearings (Figure 11)
• 2 on the drum axles (Figure 12)
• 3 on the differential (Figure 12)
• 2 on the reel countershaft bearings (Figure 13)
• 2 on the belt idler pivots (Figure 14)
1. Wipe each grease fitting with a clean rag.
2. Pump grease into each fitting until it begins to get
difficult to pump the gun.
Important: Do not apply too much pressure or
grease seals will become permanently damaged.
3. Wipe off excess grease.
Figure 11
Figure 12
19
Figure 13
Figure 14