Toro 29639 Operator's Manual

50 cm mulching/rear bagging
Hide thumbs Also See for 29639:

Advertisement

Quick Links

50cm Mulching/Rear Bagging Lawn Mower
Model No. 29639—Serial No. 310000001 and Up
Introduction
This rotary-blade, walk-behind lawn mower is
intended to be used by residential homeowners
or professional, hired operators. It is designed
primarily for cutting grass on well-maintained lawns
on residential or commercial properties. It is not
designed for cutting brush or for agricultural uses.
Read this information carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for operating
the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. Figure 1
identifies the location of the model and serial numbers
on the product. Write the numbers in the space
provided.
Figure 1
1. Model and serial number plate
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety alert symbol
(Figure 2), which signals a hazard that may cause serious
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
injury or death if you do not follow the recommended
precautions.
1. Safety alert symbol
This manual uses two words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
This product complies with all relevant European
directives. For details, see the separate product specific
Declaration of Conformity (DOC) sheet.
For models with stated engine horsepower, the gross
horsepower of the engine was laboratory rated by the
engine manufacturer in accordance with SAE J1940.
As configured to meet safety, emission, and operating
requirements, the actual engine horsepower on this class
of lawn mower will be significantly lower.
Do not tamper with the engine controls or alter the
governor speed; doing so may create an unsafe condition
resulting in personal injury.
Safety
Improperly using or maintaining this mower can
result in injury. To reduce the potential for injury,
comply with these safety instructions.
Toro designed and tested this mower for reasonably safe
service; however, failure to comply with the following
instructions may result in personal injury.
To ensure maximum safety, best performance, and
to gain knowledge of the product, it is essential
that you and any other operator of the mower read
and understand the contents of this manual before
the engine is ever started. Pay particular attention
to the safety alert symbol (Figure 2) which means
Caution, Warning, or Danger—"personal safety
Register at www.Toro.com.
Form No. 3363-278 Rev A
Operator's Manual
Figure 2
Original Instructions (EN)
Printed in the USA
All Rights Reserved

Advertisement

Table of Contents
loading

Summary of Contents for Toro 29639

  • Page 1 For models with stated engine horsepower, the gross additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model horsepower of the engine was laboratory rated by the and serial numbers of your product ready. Figure 1 engine manufacturer in accordance with SAE J1940.
  • Page 2: General Lawn Mower Safety

    instruction.” Read and understand the instruction • Before using, always visually inspect to see that because it has to do with safety. Failure to comply guards, and safety devices, such as deflectors and/or with the instruction may result in personal injury. grass catchers, are in place and working correctly.
  • Page 3: Sound Pressure

    – before refueling. • To ensure the best performance and safety, – before removing the grass catcher. purchase only genuine Toro replacement parts and accessories. Do not use will fit parts and – before making height adjustment unless accessories; they may cause a safety hazard.
  • Page 4: Safety And Instructional Decals

    Safety and Instructional Decals Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. Manufacturer’s Mark 117-4143 1. Indicates the blade is identified as a part from the original 1. Warning—read the Operator’s Manual. machine manufacturer. 2.
  • Page 5: Unfolding The Handle

    2. Filling the Engine with Oil Setup Procedure 1. Unfolding the Handle Important: Your mower does not come with oil Procedure in the engine. Before starting the engine, fill the engine with oil. Max. fill: 20 oz. (0.59 l), type: SAE 30 or SAE 10W-30 detergent oil with an API service classification of SF, Folding or unfolding the handle improperly can SG, SH, SJ, SL, or higher.
  • Page 6: Product Overview

    30 days old. Figure 6 1. Rear discharge deflector (optional) Specifications Model Weight Length Width Height 29639 75 lb 57 in 21 in 39 in (34 kg) (144 cm) (54 cm) (145 cm) Figure 7...
  • Page 7: Checking The Engine Oil Level

    Checking the Engine Oil Level Adjusting the Cutting Height Service Interval: Before each use or daily 1. Move the mower to a level surface. Adjusting the cutting height may bring you into 2. Remove the dipstick and wipe it with a clean cloth. contact with the moving blade, causing serious 3.
  • Page 8: Starting The Engine

    Starting the Engine Using the Self-propel Drive 1. Firmly push in the primer 3 times with your thumb, To operate the self-propel drive, squeeze the self-propel holding the primer in for a second before releasing drive bar (Figure 13) toward the handle and hold it. it each time (Figure 10).
  • Page 9: Mulching The Clippings

    Check the grass bag frequently. If it is damaged, install a new Toro replacement bag. The blade is sharp; contacting the blade can result in serious personal injury. Stop the engine and wait for all moving parts to stop before leaving the operating position.
  • Page 10: Operating Tips

    • Replace the blade when necessary with a Toro • Slow down your mowing speed if the mower does replacement blade.
  • Page 11: Recommended Maintenance Schedule(S)

    Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Change the engine oil. After the first 5 hours • Check the engine oil level. •...
  • Page 12: Replacing The Air Cleaner

    Replacing the Air Cleaner Changing the Engine Oil Service Interval: Yearly Service Interval: After the first 5 hours 1. Press down on the latch tabs on top of the air cleaner Yearly cover (Figure 20). 1. Ensure that the fuel tank contains little or no fuel so that fuel does not leak out when you tip the mower onto its side.
  • Page 13: Servicing The Spark Plug

    Figure 23 1. Center electrode insulator 2. Side electrode 3. Air gap (not to scale) 6. Install the spark plug and the gasket seal. Figure 22 7. Torque the plug to 15 ft-lb (20 N-m). 1. The oil level is at its 3.
  • Page 14: Adjusting The Self-Propel Drive Cable

    Figure 25 1. 1 to 1-1/2 inches (25 to 38 4. Cable support nut 2. Self-propel drive bar 5. Cable support 3. Cable jacket Figure 24 2. Hold the self-propel bail 1 to 1-1/2 inches (25 to 38 Important: Position the curved ends of the mm) from the handle (Figure 25).
  • Page 15: Folding The Handle

    Folding the Handle Folding or unfolding the handle improperly can Figure 26 damage the cables, causing an unsafe operating condition. • Do not damage the cables when folding or 2. When no more clippings come out, stop the water unfolding the handle. and move the mower to a dry area.
  • Page 16: Troubleshooting

    Troubleshooting Problem Possible Cause Corrective Action The engine does not start 1. The wire is not connected to the spark 1. Connect the wire to the spark plug. plug. 2. The primer has not been pressed. 2. Press the primer 3 times. 3.
  • Page 17 Notes:...
  • Page 18 Notes:...
  • Page 19 Spypros Stavrinides Limited Cyprus 357 22 434131 Surge Systems India Limited India 91 1 292299901 T-Markt Logistics Ltd Hungary 36 26 525 500 Toro Australia Australia 61 3 9580 7355 Toro Europe BVBA Belgium 32 14 562 960 374-0102 Rev D...
  • Page 20 Contact your seller to arrange service of the product. If for any reason materials or workmanship. The following time periods apply from the date it is impossible for you to contact your seller, you may contact any Toro of original purchase: Authorized Distributor to arrange service.

Table of Contents