Table of Contents
Advertisement
Maintenance
Lubrication
Service Interval: Every 50 hours
The debris blower has bearings and bushings that must
be lubricated regularly. If the machine is operated under
normal conditions, lubricate bearings with No. 2 general
purpose lithium base grease after every 50 hours of operation.
Lubricate fittings immediately after every washing, regardless
of the interval listed.
The lubrication points are as follows:
Drive pulley (Figure 21)
Figure 21
Shown with cover removed
Castor wheel shaft (2) (Figure 22)
Figure 22
Drive shaft (Figure 23)
Checking the Gear Box
Lubrication
Service Interval: Every 50 hours
1. Position the machine and blower on a level surface and
G021632
lower the blower.
2. Remove the (5) screws and washers securing the gear
case cover to the blower (Figure 24).
1
1. Cover
2. Washer
3. Remove the cover to expose the blower gear case
(Figure 24).
4. Remove the check/fill plug from the side of the gear
box (Figure 25).
16
Figure 23
2
G022000
4
Figure 24
3. Screw
4. Gear box
G021633
3
Advertisement
Table of Contents
