Z Master
with 42in and 48in Direct-Collect Cutting Unit
Model No. 74310—Serial No. 316000001 and Up
Model No. 74311TE—Serial No. 316000001 and Up
Model No. 74312—Serial No. 316000001 and Up
Model No. 74313—Serial No. 316000001 and Up
This product contains a chemical or chemicals known to the State of California to
The engine exhaust from this product contains chemicals known to the State of California
Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
© 2016—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
8000 Series Riding Mower
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
to cause cancer, birth defects, or other reproductive harm.
Description
No parts required
Rear caster wheel
Bolt (1/2 x 13 inches)
Locknut (1/2 inch)
Long guard
Guard
Bolt (1/4 x 1 inch)
Flat washer (1/4 inch)
Retainer nut (1/4 inch)
No parts required
No parts required
No parts required
Wing nut (1/4 inch)
No parts required
No parts required
Register at www.Toro.com.
WARNING
CALIFORNIA
Qty.
–
1
1
1
1
1
4
4
4
–
–
–
2
–
–
Form No. 3406-121 Rev A
Setup Instructions
Use
Open the crate.
Remove the machine from the crate.
Install the PTO shaft guards
(International machines only).
Check the tire pressure.
Check the engine-oil level.
Check the torque of the wheel lug nuts.
Install the battery.
Charge the battery.
Check the hydraulic Fluid.
Original Instructions (EN)
All Rights Reserved *3406-121* A
Printed in the USA.