Switching On And Off; Before Using For The First Time; Operating The Wine Conditioning Unit; Switching On - Miele KWT 6322 UG Operating And Installation Instructions

Before using for the first time

Packaging material
 Remove all packaging material from
the inside of the appliance.
Protective foil
Stainless steel surfaces have a layer of
protective foil to prevent scratching dur-
ing transportation.
 Do not remove the foil until the wine
conditioning unit has been installed in
its final location. Start at one of the
top corners.
Cleaning
Please refer to the relevant instruc-
tions in "Cleaning and care".
 Clean the inside of the appliance and
the accessories.

Switching on and off

Operating the wine condition-
ing unit
A light touch of the finger on the
sensors is all that is required to operate
this wine conditioning unit.
A tone will sound each time a sensor is
touched. You can deactivate this, if you
wish (see "Selecting further settings -
Audible tones").

Switching on

When the wine conditioning unit is con-
nected to the electrical supply, the
mains connection symbol  will ap-
pear in the display after a short while.
 Touch the On/Off sensor.
The mains connection symbol  will
go out and the wine conditioning unit
will start to cool.
The sensors for the upper and the lower
wine conditioning zones will then ap-
pear in the control panel. The selected
zone will be highlighted yellow and the
temperature of the selected zone will
show in the display.
The first time the appliance is switched
on the sensors for the wine conditioning
zones and the Alarm symbol  will
flash until the selected temperature has
been reached in the zones.
As soon as the set temperature has
been reached, the sensor for the re-
spective wine conditioning zone will
light up constantly. The alarm sym-
19