Sanyo FWBP706F Owner's Manual page 58

Problem
Repeat setting does not work with
a Blu-ray Disc™
Cannot play back 3D.
Cannot load a Blu-ray Disc™ (that
is stuck in Loading Mode and
cannot Open the disc tray to Eject
the disc.
Cannot read a USB Memory Stick.
Cannot play back Photo fi les from
a disc.
Cannot fi nd a Photo fi le.
Cannot play back Music fi les from
a disc.
Cannot fi nd a Music fi le.
Music fi les play choppy.
No Audio signal from Surround
system of the audio system.
Cannot connect to the Internet
although the Connection Test
passes.
Cannot connect to the Network.
Cannot use "Auto" to connect to
the Access Point.
EN
Repeat setting may be unavailable with some Blu-ray™ discs.
3D Blu-ray™ discs are not supported by this unit.
Unplug unit from AC outlet for 20 seconds. Plug unit back in and press
the [ (OPEN/CLOSE)] on the unit to Eject the disc.
The format of the USB Memory Stick is not compatible with this unit.
If the USB Memory Stick has been formatted on a PC or another device,
the fi le system may be incompatible with this unit. This unit supports the
FAT16 / FAT32 fi le systems.
Make sure that the disc was recorded in the UDF, ISO9660 or JOLIET
format.
Make sure that the fi le extension is .jpg / .JPG / .jpeg / .JPEG. / .png / or
.PNG.
Make sure that the disc was recorded in the UDF, ISO9660 or JOLIET format.
Confi rm that the Bitrate and Sampling Frequency are compatible with this
unit. (Refer to page 20)
Make sure that the fi le extension is MP3, AAC or FLAC for Music fi les.
CDs/DVDs containing FLAC (.fl ac) fi les with high frequency and large
quantization bit rates may not play properly. In such cases, copy the
Music fi les to a Blu-ray Disc™ or USB Memory Stick, then try playing.
Make sure the audio system is turned On.
Check the Input mode on the audio system if it is on the correct channel.
Check if the Surround system is compatible with either Bitstream or
LPCM. If not sure please check the User Manual or contact the Surround
Manufacturer. Once confi rmed check the setting in the "Setup" on this
unit.
Increase the volume level on the Surround system.
Make sure that the Ethernet cable is properly connected to the Modem /
Router.
Confi rm that another device, such as a PC, can connect to the Internet.
Check to see if the Modem / Router has Power turned On.
Make sure that the Ethernet cable is properly connected to the Modem /
Router.
Confi rm if the Internet light is showing activity (light blinking) on the
Modem / Router.
Check network settings on the unit.
Turn Off this unit and the modem/Router (if it has a Power button), then
unplug their AC cords. After 30 seconds, plug them back in and turn the
devices back On. If you have a Telephone / Internet modem with your
cable service, then you may have to use its Reset button or remove the
Backup Battery to Reset this type of modem. Now wait for the lights to
show activity and try reconnecting.
Check the cable connection to the Router when connecting with an
Ethernet cable.
Confi rm "Network Status" in the Setup.
Turn On the DHCP function on the Router.
If the Access Point's security mode is set to "WEP", change the setting to
"WPA" or "WPA2 (recommended)", then try "Auto" again. Refer to
D
" " on page 44. (For Access Point confi guration, please consult
Note
its User Manual or Manufacturer.)
Connect the unit to the Access Point using "Scan" or "Manual" mode.
58
T ip
continued on next page