Table of Contents
Advertisement
Setting Character Attributes ([ 英字形 ]/[ 字大小 ]/[ 字寬 ]/
[ 字體 ]/[ 底線 ]/[ 對齊 ]/[ 字距 ]/[ 縱印 ])
You can set character attributes by label or by each line, both before and
after entering text.
Setting Character Attributes by Label
(
)
/
value for the attribute
entry screen.
Setting Character Attributes by Each Line
1. Using
/
, move the cursor to the line where you wish to change the
character attribute.
2. Press (
) and (
NOTE
• You can press the button (
• (
) displayed on the left side of the
character attribute that appears when you
press (
) and (
are now applying the attribute for that
specific line only.
• When different attribute values are set for
each line, the value will be displayed as *****
when you press (
using
or
change the setting on this screen and then press (
the text entry screen, the same change will be applied to all lines of
the label.
• When [ 字大小 ] is set to [ 自動 ] and all the text is entered in
uppercase, the text is automatically adjusted to print in the largest
font size possible for each tape width. This font size is larger than the
largest font size available in the font settings for each tape width.
Setting Character Attributes ([ 英字形 ]/[ 字大小 ]/[ 字寬 ]/[ 字體 ]/[ 底線 ]/[ 對齊 ]/[ 字距 ]/[ 縱印 ])
Select an attribute
(
) or (
) to display the attributes.
) indicates that you
), select an attribute
, and then press (
(
) or (
)
(
) to set [ 縱印 ].
) or (
EDITING A LABEL
)
/
Set a
) to return to the text
). When you
) to go back to
24
Advertisement
Table of Contents
