Figure 1.8 Message Of Requesting Access To Virtual Console In Second Terminal Pc - Fujitsu PRIMEQUEST 2000 Series Administration Manual

CHAPTER 1 Network Environment Setup and Tool Installation
1.6 Management Tool Operating Conditions and Use
- When resolution of window in server is 800 x 600, a part of window displayed in video redirection may
luck or track of mouse cursor may remain during installing Linux.
- While the video redirection is being used, a warning message indicating that the digital signature is
expired may be displayed. Since this warning message does not affect the operation of Java Application,
click the [Execute] button. To avoid displaying this waning message every time the video redirection is
connected, check the check box for [Always trust content from this publisher], and click the [Execute]
button.
- Network communication problems between the terminal and PRIMEQUEST may cause a session
interruption, resulting in the [Video Redirection] window failing to respond to user operation. In such cases,
the window cannot be closed normally. Reconnect to the network after forcibly ending the video
redirection.
- If below problems occur while using video redirection, reconnect video redirection.
- No response comes from video redirection and any operation cannot be performed.
- Display of video redirection window remains black or 'No Signal'.
- Error dialog of video redirection appears and any operation cannot be performed.
- Window of video redirection is disconnected unintentionally.
- If you use RHEL6 or RHEL7, windows for various settings may not be displayed paritially because
maximum resolution of display is 1024 x 768 when you connect to the partition by only video redirection.
Set the resolution of display to higher than 1024 x 768 by following steps. Following steps show the
procedure to set to 1600 x 1200 as an example.
1. Execute init 3 to stop Xwindow.
# /sbin/init 3
2. Execute Xorg -configure command to create xorg.conf.new
# Xorg –configure
3. Execute cvt x y to create modeline (x, y: pixel number). 1600 x 1200 is set in following example.
# cvt 1600 1200
# 1600x1200 59.87 Hz (CVT 1.92M3) hsync: 74.54 kHz; pclk:
161.00 MHz Modeline "1600x1200_60.00"
2160
4. Edit xorg.conf.new to add ModeLine to Section "Monitor".
Section "Monitor"
Identifier
VendorName
ModelName
ModeLine
1200 1203 1207 1245 -hsync +vsync
EndSection
5. Change name of xorg.conf.new to xorg.conf, and put it in /etc/X11/xorg.conf
6. Reboot the partition. After rebooting partition, resolution of display becomes 1600 x 1200.
1600 x 1200 is added to choices of resolution in property of display.
Note
If you set higher resolution than default, response of video redirection becomes slower.
Below description is how to connect video redirection.
1. First terminal PC is connected to a partition by video redirection with Full Virtual Console Access.
2. If you connect to same partition by video redirection, a message requesting permission to virtual console
access appears in second terminal PC.

FIGURE 1.8 Message of requesting access to Virtual Console in second terminal PC

1200 1203 1207 1245 -hsync +vsync
"Monitor0"
"Monitor Vendor"
"Monitor Model"
"1600x1200_60.00"
161.00 1600 1712 1880
161.00 1600 1712 1880 2160
20
CA92344-0537-08