Labels To Configure Injection During Start Conditions - Bosch MS 6 Manual

4.1.7.1
Bosch Motorsport
Main Data Labels for injection
LP‐system
HP‐system
Notice: Before calibration starts, turn off Lambda closed loop control.
CWLC
Labels to configure Injection during Start
Conditions
After initial calibration the start factors for injection may be optimized.
Injection during start conditions
AOINJ_START_NMOT
MP_INJSTART
FINJSTART_TMOT
FINJSTART_NMOT
Notice: For details please refer to the Function Description INJPRECTRL
ECU MS 6
Prepare Data Base | 4
Standard choice to end of injection
pulse, refers to combustion TDC (de‐
grees before TDC). Make sure, the in‐
jection is finished before the inlet valve
closes. Try 200° ‐ 300° for first startup.
Standard choice to start of injection
pulse.
Codeword for enabling of the Lambda
closed loop control. Set to 0 during ini‐
tial calibration, afterwards = 1
Map begin/end of injection during start
Decay of the start enrichment factor
over the number of engine revolutions
Basic start enrichment factor depending
on the engine temperature
Basic start enrichment factor depending
on the engine speed
33 / 78