Sanyo DC F200 Instruction Manual page 2

CAUTION-USE OF CONTROLS OR ADJUSTMENTS
OR PERFORMANCE OF PROCEDURES OTHER
THAN THOSE SPECIFIED IN THE OPERATING
[01
INSTRUCTIONS MAY RESULT IN HAZARDOUS
RADIATION EXPOSURE.
CIASS 1 LASER PRODUCT
LUOKAN1 LASERU4TE
KLASS lLASERAPPARAT
THE COMPACT DISC PLAYER SHOULD NOTBE
ADJUSTED OR REPAIRED BY ANYONE EXCEPT
PROPERLY QUALIFIED PERSONNEL.
-1
CAUTION-INVISIBLE LASER RADIATION WHEN OPENAND
I
INTERLOCKSDEFEATED.AVOID EXPOSURETO BEAM.
ADvARsEL-usYNLIG LAsERsTRILINGvED ABNING, NAR
SIKKERHEDSAFBRYDERE ERUDEAFFUNKTION, UNDG~LfDS/HTELSE
A
FORSTR~LING.
VARNING-OSYNLIG LASER STR~LNING,NAR DENNADELAROPPNAD
OCHSPARRARURKOPPLAD. STR~LENARFARLIG.
VORSICHT:UNSICHTBARE LASERSTRAHLUNGTRITT AUS,WENN
DECKELGEOFFNETUNDWENNSICHERHEITSVERRIEGELUNG
A
UBERBRucKTIsT. Ni12HT,DEMSTRAHLAUSSETZEN.
VARO! Avattaessa ia suoialukitus ohitettaessa olet altfiina
nakymattomalle Ia;ersateilylle. Ala katso ateeseen.
PRECAUTIONS
If water should enter the unit, electrical shock or malfunction may
result. Always use it in a place where there is low humidity and little
dust.
Do not use where there are extremes of temperature (below 5°C or
exceeding 35°C) or where direct sunlight may strike it.
Because of the CD player's extremely low noise and wide dynamic
range, there might be a tendency to set the volume on the amplifier
unnecessarily high. Doing so may produce an excessively large
output from the amplifier which could damage your speakers.
Sudden changes in the ambient temperature maycausecondensation
to form on the optical lens inside the unit. If this happens, take out the
disc, leave the unit for about 1 hour, and then proceed to operate.
When carrying the unit, be sure to remove any discs which may
be inside and press the POWER button on the front panel to turn
the power off. The STANDBY indicator lights. After several
seconds, the STANDBY indicator goes out. Then unplug the
mains lead from the AC outlet. Carrying the unit with any discs
inside may damage the discs andlor the unit.
Thesystem'sspeakers use powerful magnets. Do not place timepieces,
credit cards, cassette tapes or video tapes, etc. near the speakers.
1
Do not install this equipment in a confined space, such as a book case
or built in cabinet.
Before use
Remove the shipping screw from the rear of the unit as shown in figure.
This screw is used to secure the CD mechanism during shipment and
should be retained for future use as shown in figure,
Shipping screw
Green arrow
Before transportation
1.
2,
3.
4,
Turn on the power and remove all discs from the unit.
Press the POWER button on the front panel to turn the power off
The STANDBY indicator lights. After several seconds, the STANDBY
indicator goes out.
Then unplug the mains lead from the AC outlet.
Reinstall the shipping screw as shown in figure.
1