GE WPGT9350 Technical Service Manual page 57

18. Attach the washer control board to the new
backsplash by replacing the 4 Phillips head
screws removed from the washer control
board earlier.
19. Connect the washer control board to the new
backsplash by sliding the ribbon connector on
the new backsplash onto the metal pins on
the control board and pushing in. Make sure
the ribbon is not twisted before inserting the
connector.
20. Secure the new washer backsplash to the
rear cover using the 2 Phillips head screws
removed earlier.
Screws
– 57 –
21. Place the gray wire from the serial port under
the strain relief of the new backsplash.
Strain Relief
22. Insert the tabs on the bottom front of the new
backsplash into the slots on the washer and
rotate the backsplash into place.
23. Secure the new backsplash to the washer
using the 2 Phillips head screws removed
earlier.
Screw
Rear of Washer
24. Reconnect house utilities.
25. Plug the washer and dryer back in.
Screw