Self Check - Haier HMS1460B Service Manual

SERVICE MANUAL
HMS1460B

9-2. Self check

1.How to start
Press the "temperature" and "delay" button at the same time, then switch on the
power, wait for about 3 seconds, the LED will display "TEST", then you can press
"start/pause" to let washing machine start test function.
2. Test item
1) when the door switch is closed for ten seconds, 88:88 will be displayed.
2) when the main wash valve allows water to let in for 3 seconds, 77:77 will be
displayed.
3) when the prewash valve allows water to let in for 3 seconds, 77:77 will be
displayed.
4) when the softy water valve allows water to let in for 3 seconds, 77:77 will be
displayed.
5) when the main wash valve, the prewash valve and also the softy water valve
allow water to let in for 3 seconds at the same time, 77:77 will be displayed.
6) Heater runs for ten seconds, 66:66 will be displayed.
7) the drain pump runs for about 1 mins, 55:55 will be displayed
8) the motor runs for 10 seconds with the spin speed 400rpm, then for ten
seconds with the spin speed 1000rpm, 44:44 will be displayed
Model selection
1.Press the temperature button and the power button at the same time for 4
seconds, and it will enter the model-selection mode.
2.The default display shows 1460. Press the speed button to choose
1460/1450/1260/1250/1060/1050/960/950/860/850/760/750 till the needed
model.Then press the reservation key and the model can be stored. The model
can not be changed after storage.
3.If you want to change the model again after storage, you can cut off the NTC
and do the cycle adjustment.
4.Model HMS1460B you should choose 1460.
Front Load Washing Machine