IFU 104.5 ADDITIONAL EQUIPMENT REQUIRED: • ELECTRIC HAND ROUTER • 30mm ROUTER GUIDE BUSH • TUNGSTEN CARBIDE ROUTER CUTTER - 12.7mm DIA X 50mm (1/2” DIA X 2”) • MINIMUM OF 2 QUICK ACTION OR ‘G’ CLAMPS For 420, 500, 600, 616, 620 , 650 &...
Page 3
MALE JOINT - where to mark the pencil line to determine the position of the jig Alternately, list of authorised DEWALT repair agents and full details of our after-sales service and contacts along the length of the worktop. WORKTOP FACE UP are available on the internet at: www.2helpU.com...
Page 4
(minor adjustment may be necessary) see diagram B) ∡ If your DEWALT product becomes defective due to faulty materials or workmanship within 12 months of the Make sure the pins in the holes marked ’♀ ’ are firmly pushed...
Safety Notes Cutting to Length Before starting ……... • Never cut worktop to length until all joints are complete and have been checked for When producing a male joint, left or right hand, the correct fit. position of the worktop jig has to be calculated. It is easier •...
Page 6
FEMALE JOINT Refer to the diagrams on the different joints FEMALE JOINT For the female cut in your worktop, position the Left Hand 90° Joints Right Hand 90° Joints available. For the female cut in your worktop, position the jig as jig as shown in diagram A and the worktop face down and the post shown in diagram A and the worktop face up and the post formed formed (curved edge) towards you.