Programmable Settings; Programming Via Direct Commands; Direct Commands Chart - Panasonic KX-TS730AZ Operating Instructions Manual

Programmable Settings

Programming via direct commands

You can program features using "direct commands"– special codes that take you directly
to the feature you wish to program and allow you to select the desired setting. There is no
need to scroll through the unit's sub-menus.
Details of each feature can be found on the corresponding pages.
Important:
L Before programming, make sure the unit is not being used.
1
Press {MENU} ({F2} key).
2
Press {#}.
Enter direct No.
:
BACK
3
Enter the desired feature code (shown below).
4
Enter the desired setting code (shown below).
L This step may vary depending on the feature being programmed.
5
Press {SAVE} ({F3} key).
6
Press {STOP} to exit programming mode.
Note:
L If the unit beeps 5 times, you entered an invalid code. Enter the correct code.
L If you enter the wrong code, press {CLEAR}.
L To exit programming, press {STOP} at any time.

Direct commands chart

Note:
L The default settings are indicated by *.
Feature
Ringer volume
Ringer tone
LCD contrast
Key tone
Set area code
20
Feature code Setting code
{1}: Low {2}: Medium
{1} {6} {0}
{3}: High* {0}: Off
{1}–{3}: Tone pattern 1*–3
{1} {6} {1}
{1}–{6}: Level 1–6 (Default: 3)
{1} {4} {5}
{1}: On* {0}: Off
{1} {6} {5}
Go to step 2 on page 24.
{2} {5} {5}
Page
page 23
page 23
page 23
page 25
page 24