Makita HM1317C Technical Information page 7

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-3. Inside of Tool holder section, Impact bolt
DISASSEMBLING
(1) Disassemble Handle section as illustrated in Fig. 4 and stand the machine as illustrated in Fig.5.
(2) Remove six M8x35 Hex socket head bolts with Hex wrench 6 and disassemble Tool holder section as illustrated in
Figs. 10 and 11.
Fig. 10
Remove six M8x35 Hex socket
head bolts with Hex wrench 6
as illustrated below.
Hex Wrench 6
Pipe
(as Extension bar)
Fig. 11
O rings and X ring can be replaced.
ASSEMBLING
Take the disassembling step in reverse. Pay attention to the directions and difference shown in Fig. 12.
Fig. 12
Pay attention to the directions
X ring 36
O ring 36
Before separating Tool holder section,
strike machine with the grip end of
Plastic hammer as illustrated below.
HM1307C,
HM1317C
O ring 67
Tool holder
Washer 30
Shoulder ring 32
Rubber ring 36
Tool holder
Washer 30
Rubber ring 36
HM1307CB,
HM1317CB
X ring 36
O ring 45
*Impact Bolt
*Sleeve 43
Sleeve 43 and Impact bolt are not interchangeable
between CB models and C models.
*Sleeve 43
*Impact Bolt
The following parts come out
from Tool holder.
Urethane ring (Refer to Fig. 12.)
Flat washer 24
Sleeve 43
Impact bolt
Shoulder ring 32
O ring 36
HM1307CB, HM1307C,
HM1317CB HM1317C
63mm 55mm
P 7/ 19