Panasonic TX-P55ST50E Operating Instructions Manual page 6

3
Attach the bracket
and fix with assembly screws
C
■
Securing the TV
Use the assembly screws
TX-P50ST50E) or
securely.
●
Tighten the four assembly screws loosely at first,
then tighten them firmly to fix securely.
●
Carry out the work on a horizontal and level
surface.
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way
when using the wall-hanging bracket or repacking the
TV.
1 Remove the assembly screws
TX-P50ST50E) or
2 Pull out the pedestal from the TV.
3 Remove the assembly screw
4 Remove the assembly screws
5 Remove the assembly screws
the base and pull out the neck.
Preventing the TV from falling over
Using the fall-prevent screw hole and a screw (commercially available), securely fix the body of the pedestal to the
installation surface.
●
The place where the pedestal is to be fixed should be thick enough and made of hard material.
6
to the tabs of the neck
B
Tabs (top)
D
(TX-P42ST50E,
(TX-P55ST50E) to fasten
(TX-P42ST50E,
(TX-P55ST50E) from the TV.
from the cover.
from the bracket.
from the back of
4
Attach the cover
screw
E
Arrow mark
Adjusting the panel to your desired angle
● Do not place any objects within the full rotation range.
(TX-P42ST50E, TX-P50ST50E)
Screw (not supplied)
Diametre: 3 mm
Length: 25 - 30 mm
Screw hole
and fix securely with assembly
A
A / B
Hole for pedestal
installation
(View from the top)
TX-P42ST50E: 15°
TX-P50ST50E: 10°