Advertisement
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
9a
Bundling connector cables
Press down on the upper section of
1
the clamper with your thumb and pull
the edge using your index finger to
remove the hook.
Hook
Edge
9b
Bundling cables below the connector
Tip
Clamp a single cable using the cable
1
clamper and insert the tip into the in-
ner hole.
Example of
clamped cables
Installation (mounting to wall)
10
Mount wall mounting bracket B (wall side)
Be sure to attach the fall prevention strings (2 units) on the hooks of wall mounting
1
bracket B (wall side).
Mount the main unit on wall mounting bracket B (wall side).
2
Bundle the cables and apply the
2
clamper hook.
Inner hole
Outer hole
Bundle all cables and insert the tip
2
into the outer hole.
Clamper
Cable
clamper
Caution
To prevent damage to the
wall, make sure that the
main unit is securely
mounted on the notches of
wall mounting bracket B
(wall side) before letting go
of the main unit.
Always work in pairs or
more when installing the
unit on the wall.
14
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
11
Angle adjustment
This wide-screen LCD television wall mounting bracket can be installed in 4 angles:
5° upsweep, vertical, 5° downsweep and 10° downsweep.
Set the angle by adjusting the notches of wall mounting bracket B (wall side) and the
concave section of wall mounting bracket A (main unit side) to the desired angle by
referring to the diagrams below.
Upper notch
5° upsweep
Fixing
hole
Lower notch
Upper notch
5° downsweep
Fixing
hole
Lower notch
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
12
Angle fixing method
To prevent the main unit from falling, fix the main unit using angle fixing screws (2
units) from both sides using the fixing holes located on wall mounting brackets A and
B (main unit side and wall side).
If the fixing holes of the brackets do not align, installation is insufficient.
Check the installation again and fix so that screw holes are aligned.
Example: When adjusting the angle to 10° downsweep.
Upper notch
Vertical
Fixing
hole
Lower notch
Upper notch
10° downsweep
Fixing
hole
Lower notch
Fixing hole
Angle fixing screw
(M4x10 mm)
15
Advertisement
