Setup; Part Names And Functions; About The Led Indicator; Setup Overview - Panasonic KX-HNS102 Installation Manual

Part names and
functions
A B
Infrared sensor
LED indicator
MHIGHN/MLOWN
Used to change the sensor
sensitivity (page 14).
Rear cover
M N
Used to confirm the status of the
sensor or register the sensor to
the hub.
About the LED
indicator
You can press M N and check the
LED indicator to confirm the sensor's
status.
Indicator Status
Green, lit No motion detected
For assistance, please visit www.panasonic.com/support
Indicator
Red, lit
Red,
blinking
Green,
blinking
Off
Note:
R The LED indicator does not indicate
sensor status if the sensor has not
been registered (page 8).
C D

Setup overview

1
Initial setup
Make sure you can access the
E
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Insert the batteries
The motion sensor is battery
powered.
3
Registration
Required only if the motion sensor
was purchased separately (i.e.,
not as part of a bundle).
4
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
5
Installation
Install the motion sensor in the
desired location.

Setup

Status
Motion was detected
Sensor is out of range
of the hub
Registration mode
(You pressed and held
M N)
No battery power
7