Enable Jumbo Frames; Enable Flow Control; Configure Spanning Tree On Edge Ports; Configure Vlan - Dell S5000 Configuration Manual

FTOS(conf-if-range-te-0/0-47)#switchport
FTOS(conf-if-range-te-0/0-47)#no shutdown
2.8

Enable Jumbo Frames

FTOS(conf-if-range-te-0/0-47)#mtu 12000
2.9

Enable flow control

FTOS(conf-if-range-te-0/0-47)#flowcontrol rx on tx off
2.10

Configure spanning tree on edge ports

Note: Use the following command only on server- and storage-connected edge ports.
FTOS(conf-if-range-te-0/0-47)#spanning-tree rstp edge-port
FTOS(conf-if-range-te-0/0-47)#exit
FTOS(conf)#protocol spanning-tree rstp
FTOS(conf-rstp)#no disable
FTOS(conf-rstp)#exit
2.11

Configure VLAN

Note: Dell recommends assigning a unique
example, assign VLAN 100 on the first switch and VLAN 200 on the second switch. The following
example assigns all the ports to the VLAN, however, you may also assign individual ports to the VLAN
after they are enabled (Section 2.7). If you prefer to use the default VLAN, then you may skip this section
entirely.
FTOS(config)#interface vlan vlan_id
FTOS#(config-if-vl-###)#no shutdown
FTOS#(config-if-vl-###)#untagged tengigabitethernet 0/0-47
FTOS#exit
8 SCG2004 Dell Networking S5000 Switch Configuration Guide for SC Series SANs
vlan_id
(between 2-4094) for each switch fabric. For