Cmd Input Style; 5: Date / Time; 6: Send To Panel - Honeywell ECC-50/100 Instruction Manual

Main Menu - User Programming

CMD Input Style

CMD Input Style CMD1 and CMD2 Command Input circuits can be independently programmed
to be triggered by a Contact Closure or by the Reverse Polarity of a Notification Appliance Circuit.
When the system is programmed for Mass Notification, CMD1 and CMD2 will be programmed for
Reverse Polarity only. See Section 2.5.1 for more information.
3.2.5 Date / Time
Set the local time and date for the panel using the drop-down boxes. Pressing the Refresh button
automatically fills these fields with current information.
3.2.6 Send to Panel
After completing the desired programming on each page, click the Send to Panel button to save
changes to the panel. Selecting the Load Defaults button will apply default programming to the
given page. To then save the applied default settings to the panel, press the Send to Panel button.
The Main Menu button will disregard any programming selections and jump back to the main menu
screen. Changes made to panel programming will not be applied until log out of user programming
(selecting the Log Out button from the Main Menu) is complete. After a successful log out from the
programming utility, the panel will reboot and the changes will become effective.
Emergency Command Center Manual — P/N LS10001-000FL-E:G 5/3/2016
Figure 3.9 Tone Duration / CMD Input Types
Programming
67