Panasonic BB-HCM511A Service Manual page 25

6.3.1. Flexible Stand Mount
1. Screw the threaded mount into the stand/tripod mounting
hole.
2. Turn the grip firmly.
6.3.2. Tripod Mount
6.3.3. Ceiling/Wall Mount
n Wiring without making a hole for a cable in the ceiling or
wall
For BB-HCM531A:
Before following the procedures below, we recommend passing
all cables (AC adaptor, LAN, audio/video, etc.) through a duct
(i.e., hose, tube, etc.) for proper waterproofing.
1. Secure the safety wire to the camera using screw A
(included) and washer S (included).
•Make sure you attach the safety wire when mounting the
camera, to prevent the camera from falling.
2. Remove the tab on the flexible stand. Then pass the cables
through the notch.
3. For BB-HCM511A:
Connect all necessary cables (AC adaptor, LAN, audio/
video, etc.). Then skip to step 7.
For BB-HCM531A:
Pass the cables through the connector cover, and then
connect all necessary cables (AC adaptor, LAN, audio/
video, etc.). Attach the connector cover by fastening the
two screws.
4. Attach the sunshade by fastening the two screws.
5. Wrap the cables in the included foam strip and insert the
foam strip into the opening of the connector cover.
• Leave about 10 mm (3/8 inches) of the foam exposed, as
shown.
6. Wrap the first 20 cm (7 7/8 inches) of the cables (starting
with the connector cover) using the included self bonding
tape. Make sure to wrap the opening of the connector cover
thoroughly (three or four times).
• Stretch the tape to twice its length when you wrap the
cables.
• Overlap the tape when you wrap the cables.
25
BB-HCM511A/BB-HCM531A