Panasonic KX-TDA100 Installation Manual page 164

3.3 Installation of the KX-TDA Maintenance Console
Starting the KX-TDA Maintenance Console and Assigning the Basic
Items (Quick Setup)
When you start the KX-TDA Maintenance Console with the Installer Level Programmer Code and connect
to the Hybrid IP-PBX for the first time after initialization (with the factory default setting), Quick Setup will
launch automatically. During Quick Setup, you will set up the basic items. For details about the basic items,
refer to "1.14.2 Quick Setup" in the Feature Manual.
164 Installation Manual
1. Connect the PC to the Hybrid IP-PBX with a USB cable.
2. Start the KX-TDA Maintenance Console from the Start
menu.
3. "Information before programming" appears.
a.
Carefully read this important additional information,
which includes updates to this and other manuals.
b.
Click OK to close this window.
4. Enter the Installer Level Programmer Code (default:
INSTALLER).
The Programmer Code authorizes different programming
levels, and the Quick Setup is only available when you start
the KX-TDA Maintenance Console with the Installer Level
Programmer Code.
Note
There are 2 other Programmer Codes with limited
authorization: Administrator Level (default: ADMIN),
and User Level (default: USER).
5. a.
Click the check box to connect to the Hybrid IP-PBX.
Options will appear as shown here, on the left.
b.
Enter the system password for installer (default:
1234).
c.
Select "USB", then click OK.
Note
To connect to the Hybrid IP-PBX via USB, the KX-TDA
USB driver must be installed on the PC, as explained
above in "Installing the KX-TDA Maintenance
Console".
7. Follow the instructions of the Quick Setup wizard and
assign the basic items (Quick Setup).