Panasonic KX-TDE200 Installation Manual page 83

WARNING
A lithium battery is used in the IPCMPR card. There is a risk of explosion if the battery is replaced
with the incorrect type. Dispose of used batteries according to the manufacturer's instructions.
CAUTION
•
The SD Memory Card contains software for all the processes of the PBX and all the customer data. It
can be easily removed and taken away from the PBX by a third party. Therefore, do not allow
unauthorised access to prevent data leakage.
•
Do not remove the SD Memory Card while power is supplied to the PBX. Doing so may cause the PBX
to fail to start when you try to restart the system.
•
To prevent data leakage, render the SD Memory Card physically unusable before disposal.
Notice
•
Some built-in ESVM card features are not supported for KX-TDE100/KX-TDE200 PBXs released with
MPR software version 2.01 or earlier:
–
The Music on Hold feature is not recommended to be used with the built-in ESVM card feature.
–
High quality recording cannot be performed using the built-in ESVM card feature.
A hardware upgrade is required to enable these features on the IPCMPR card. Alternatively, ESVM2/
ESVM4 cards mounted on an OPB3 card already support these features.
•
Use only the SD Memory Card included with the PBX.
•
The SD Memory Card must be inserted in the SD Memory Card slot of the IPCMPR card before startup.
Note
•
Make sure to use the MNT port for PC connection, and the LAN port for LAN connection.
•
The maximum length of the cable to be connected to the IPCMPR card is 100 m.
•
When connecting the RJ45 connector, attach the ferrite core included with the PBX. Refer
to "3.2.9 Attaching a Ferrite Core".
•
For details about Virtual Slots, refer to "1.3.3 System Capacity".
•
For details about the activation keys, refer to "2.1 Information about the Activation Keys".
•
For details about connecting to a LAN, refer to "3.11 LAN Connection".
•
For details about connecting peripherals, refer to "3.10.1 Connection of Peripherals".
•
For details about System Initialise Switch, refer to "3.13.1 Starting the PBX".
•
For details about Reset Button, refer to "5.1.4 Using the Reset Button".
Pin Assignments
MNT Port/LAN Port (10BASE-T/100BASE-TX)
No.
1
1
2
3
8
4-5
6
7-8
Signal Name
TPO+
TPO-
TPI+
Reserved
TPI-
Reserved
Input (I)/Output (O)
O
O
I
–
I
–
3.3.1 IPCMPR Card
Function
Transmit data+
Transmit data-
Receive data+
–
Receive data-
–
Installation Manual 83