Table of Contents
Advertisement
Additional Safety Warnings Specific for Abrasive
Cutting-Off Operations
a) Do not "jam" the cut-off wheel or apply excessive pressure. Do not attempt to
make an excessive depth of cut. Overstressing the wheel increases the loading
and susceptibility to twisting or binding of the wheel in the cut and the possibility
of kickback or wheel breakage.
b) Do not position your body in line with and behind the rotating wheel. When
the wheel, at the point of operation, is moving away from your body, the possible
kickback may propel the spinning wheel and the power tool directly at you.
c) When wheel is binding or when interrupting a cut for any reason, switch off
the power tool and hold the power tool motionless until the wheel comes to a
complete stop. Never attempt to remove the cut-off wheel from the cut while
the wheel is in motion otherwise kickback may occur. Investigate and take
corrective action to eliminate the cause of wheel binding.
d) Do not restart the cutting operation in the workpiece. Let the wheel reach full
speed and carefully reenter the cut. The wheel may bind, walk up or kickback if
the power tool is restarted in the workpiece.
e) Support panels or any oversized workpiece to minimize the risk of wheel
pinching and kickback. Large workpieces tend to sag under their own weight.
Supports must be placed under the workpiece near the line of cut and near the
edge of the workpiece on both sides of the wheel.
f) Use extra caution when making a "pocket cut" into existing walls or other
blind areas. The protruding wheel may cut gas or water pipes, electrical wiring or
objects that can cause kickback.
Safety Warnings Specific for Sanding Operations
a) Do not use excessively oversized sanding disc paper. Follow manufacturers
recommendations, when selecting sanding paper. Larger sanding paper
extending beyond the sanding pad presents a laceration hazard and may cause
snagging, tearing of the disc or kickback.
Safety Warnings Specific for Wire Brushing Operations
a) Be aware that wire bristles are thrown by the brush even during ordinary
operation. Do not overstress the wires by applying excessive load to the
brush. The wire bristles can easily penetrate light clothing and/or skin.
b) If the use of a guard is recommended for wire brushing, do not allow any
interference of the wire wheel or brush with the guard. Wire wheel or brush
may expand in diameter due to work load and centrifugal forces.
Additional Specific Safety Instructions for Grinders
• Always use proper guard with grinding wheel. A guard protects operator from
broken wheel fragments and wheel contact.
• Accessories must be rated for at least the speed recommended on the tool
warning label. Wheels and other accessories running over rated speed can fly
apart and cause injury. Accessory ratings must be above listed minimum wheel
speed as shown on tool nameplate.
• Hold tool by insulated gripping surfaces when performing an operation
where the cutting tool may contact hidden wiring or its own cord. Contact
with a "live" wire will make exposed metal parts of the tool "live" and shock the
operator.
WARNING: ALWAYS WEAR EYE PROTECTION WHEN USING THIS TOOL.
• Use of accessories not specified in this manual is not recommended and may
be hazardous. Use of power boosters that would cause the tool to be driven at
speeds greater than its rated speed constitutes misuse.
• Do not use circular saw blades or any other toothed blades with this tool.
Serious injury may result.
• When starting the tool with a new or replacement wheel, or a new or
replacement wire brush installed, hold the tool in a well protected area and
let it run for one minute. If the wheel has an undetected crack or flaw, it should
burst in less than one minute. If the wire brush has loose wires, they will be
detected. Never start the tool with a person in line with the wheel. This includes
the operator.
5
Advertisement
Table of Contents
