Program Diagram - Haier 21F3A-T Service Manual

9.

Program Diagram

Insert the power plug into the power line socket and insert the antenna plug into the antenna
socket on the rear panel. Press down the power switch of the TV set. The red indicator light
goes on. If no picture appears, press the button
below.
A．Program preset
1. Auto searching and storing program
Press MENU button on the remote controller then use the "
program" menu on the screen. Then Press the menu"
key to select the bar "auto search program" then press the "
want to stop ,press the key "
2. Manual search and fine tune
Press MENU button then use the "
screen. Then Press the menu"
"Manual search program" then press the "
3.Deleting channel number
Press Program up/down buttons to select a channel to skip. Press MENU to call Menu.
then use the "
menu" " item to select it.Then select "SKIP" and select SKIP to ON. Now the program
number is deleted. Repeat the above steps and select SKIP to OFF, the deleted program
number can be resumed.
B．Volume tuning
Press VOLUME buttons
C Personal preference settings
Picture modes
Press SELC PICTURE repeatedly to change the Picture Mode.
".
" item to select it.Use the " " key to select the bar
" key to call up the "TUNING" menu on the screen. Then Press the
- to increase and
on the remote controller. Follow the steps
" item to select it.Use the "
" key to call up the "tune program" menu on the
" to make sure.
+ to decrease the volume.
15
Program Diagram
" key to call up the "tune
" to make sure. If you
"