Removing Trim Waste - Canon imageRUNNER ADVANCE 8085 Maintenance Manual

Removing Trim Waste

When the trim waste tray of the Inner Booklet Trimmer becomes full, a screen prompting you to remove the trim waste appears
on the touch panel display. Follow the procedure described below to remove the trim waste.
Take care when handling the optional equipment that is attached to the machine. When an optional unit's cover is opened to replace a staple
cartridge, discard the punch waste, discard the trim waste, or clear paper or staple jams, prints may still be output if other optional units are
operating normally, and are not involved in the paper or staple jam removal procedure.
•
This procedure is necessary only if the Inner Booklet Trimmer is attached to the Booklet Finisher-D1.
•
When the trim waste tray is full, you cannot make copies or prints using the Trim mode.
1
Open the front cover of the finisher.
2
Pull out the trim waste tray.
Staple Finisher-D1/Booklet Finisher-D1/Puncher Unit-BF1/Inner Booklet Trimmer-A1 (Optional)
1
1-45